The Patrol Grade "Flat Faced" Trigger follows the same geometric pattern as our Tactical Grade Trigger, but maintains the Glock "Pre-Ignition Take Up". The trigger feels like a "Two Stage" trigger with a smooth take up, leading to a predictable break. The creepiness and "mushy" feel is gone. The Patrol Grade Trigger has been thoroughly tested to insure reliability, consistency, and safety, as well as uniformity of weight. Trigger weight is not affected unless other component changes are made. You will immediately notice the difference in your shooting performance after installation.
The trigger face is totally and geometrically flat: Look at all the match rifles used to set combat rifle marksmanship records. They all use flat triggers. Flat triggers are totally flat and straight, not just "square faced" curved triggers. "Flat and straight" triggers improve your mechanical leverage and allow you to consistently place your shooting finger in the most advantageous location for you. Additionally, these triggers maintain a more consistent feeling trigger regardless of where on that trigger your finger is placed.
The trigger safety is much wider than an OEM unit, allowing you to quickly place your finger in the optimal firing position via a tactile index and thus build improved consistency and accuracy via smooth operation through the entire length of pull. Imperceptible pre-travel and crisp reset improves the shooter’s ability to place follow up shots with speed and accuracy.
If YOU were the guy at the next Sandy Hook, or Mumbai...you would want a 100% reliable handgun with a capability for extreme surgical accuracy equal to the moment. The goal: To save innocent lives by being able to put one bullet in a terrorist's eye socket from across the room, in his face from across the street, or in his chest from down the block. That is what this trigger was designed for.
FITTING - Our triggers work with most, but not all frames. Due to Glock's manufacturing tolerances, some fitting of the safety tab may be required by a competent gunsmith. Check the outward bend angleof the connector once installed. This is done by sliding a piece of paper between the connector and the top portion of the trigger mechanism housing. The paper should slide through with a little resistance. If the paper does not slide through then the connector needs to removed and bent out slightly.
If the installed connector fits too far inwards, the trigger may not reset. This is common on some Glocks. The connectors are modeled after the Glock 3.5 pound connectors, but there are slight variances in the trigger mechanism housings which can affect the final connector angles. Please use the technique above to insure your connector bend angle is correct. If it is not, it can be manually bent outward from the trigger housing to achieve the correct fit.
RELEASE OF LIABILITY - In no event shall Suarez International be liable for any direct, indirect, punitive, incidental, special consequential damages, injury, or death whatsoever, arising out of the sale, resale, or connected with the use, misuse, or installation of its products and components. If the purchaser cannot abide by, or agree with this statement, they should not install or use our products. The purchaser/user accepts all risk.
All prices are in USD.