Loading... Please wait...



Hover over image to zoom

  • Image 1
  • Image 2
  • Image 3
  • Image 4

 Product Description


The Tactical Grade "Flat Faced" Trigger closely replicates the feel of a 1911 trigger. Our Tactical Grade Glock Trigger has been thoroughly tested to insure reliability, consistency, and uniformity of weight. You will immediately notice the difference in your shooting performance after installation.

The trigger face is totally and geometrically flat:  Look at all the match rifles used to set combat rifle marksmanship records.  They all use flat triggers.  Flat triggers are totally flat and straight, not just "square faced" curved triggers.  "Flat and straight" triggers improve your mechanical leverage and allow you to consistently place your shooting finger in the most advantageous location for you.  Additionally, these triggers maintain a more consistent feeling trigger regardless of where on that trigger your finger is placed.

The trigger safety is much wider than an OEM unit, allowing you to quickly place your finger in the optimal firing position via a tactile index and thus build improved consistency and accuracy via smooth operation through the entire length of pull.  Reduced pre-travel and crisp reset improves the shooter’s ability to place follow up shots with speed and accuracy.

Warning: This is not a trigger for a novice.  The take-up is minimal and the travel to break is almost imperceptible.  It is like a 1911 trigger.  While the firing pin safety and trigger safety remain exactly as designed, preventing the weapon from firing inadvertently unless the trigger is pulled, the trigger bar rides the edge of the trigger housing.  Some feel this makes the weapon unsuitable for carry.  We have dropped a pistol from as high as 30 feet with a primed case in the chamber, and while the trigger slipped off the shelf on the trigger housing, the primer was not touched.  If in doubt, buy the Patrol Trigger with longer pre-travel just like the factory trigger.

  • Polished Steel Glock Trigger Bar - Refined
  • Suarez "Flat and Straight" Patrol Grade Trigger Pad - 6061 Aircraft Grade T6 Aluminum
  • Suarez Trigger Safety - 6061 Aircraft Grade T6 Aluminum
  • All components Hard Anodized Type III
  • Installation Instructions
  • Drop in unit and takes less than two minutes to install.
  • Compatible with Gen 1-4 Pistols
  • Available for 9mm/40/.357 SIG, 45 ACP and 10mm
  • Gen 3 SF Models use Gen 4 Unit
  • Includes Trigger and Trigger Bar, Trigger Housing, Ejector, Extra Power Trigger Spring and OEM Connector

FITTING -  Our triggers work with most, but not all frames.  Due to Glock's manufacturing tolerances, some fitting of the safety tab may be required by a competent gunsmith.  

RELEASE OF LIABILITY - In no event shall Suarez International be liable for any direct, indirect, punitive, incidental, special consequential damages, injury, or death whatsoever, arising out of the sale, resale, or connected with the use, misuse, or installation of its products and components.  If the purchaser cannot abide by, or agree with this statement, they should not install or use our products. The purchaser/user accepts all risk.

Trigger installation and information 

 Find Similar Products by Category

You Recently Viewed...


Latest News

Suarez Newsletter

Copyright 2017 Suarez International. All Rights Reserved.

Click the button below to add the FLAT AND STRAIGHT TACTICAL GRADE TRIGGER SYSTEM - COMPLETE to your wish list.