SUAREZ PRECISION RECOIL GUIDE ROD AND SPRING FOR GLOCK - NP3™

SUAREZ NP3™ PRECISION RECOIL GUIDE ROD

We have seen the factory recoil guide rod break in extremely harsh conditions. This usually happens at the tip or the base and potentially locks up the the pistol until it can be fixed. Our guide rod was developed to enhance the reliability and durability of the Glock system under the worst conditions. Our guide rod provides faster shot to shot recovery and smoother slide cycling than is possible with the OEM guide rods.

Accuracy with the Glock system is greatly affected by the tightness in lock up. I experimented some time ago and found that even a match barrel would yield lack luster results if the slide did not lock up like a swiss safe. Moreover, the polymer factory guide rod is often not straight, leading to inconsistent tracking of the slide. The solution is a super stiff steel guide rod. With the springs we use (consistent weight), lock up tightness is increased and that is a good thing.

These guide rods are made from 4140 hardened steel with NP3™ finish. The end result is a very tough recoil guide rod with a black finish, and with corrosion resistance equal to the pistol. To further increase ultimate reliability, these guide rods are designed as uncaptured units for better reliability over captured guide rods. Perfect with any quality spring such as ISMI or Wolff.

This construction and finish also offers a lubricity and smoothness of operation not evident in the OEM spring unit, or aftermarket stainless guide rods.

• Made from 4140 hardened steel
• Enhanced reliability, accuracy and durability in extreme and harsh conditions
• Faster shot to shot recovery and smoother slide cycling
• Includes OEM weight spring

NOTE: The Glock 17/22 spring fits Glock 17,20,21,22,24,34, and 35 models and is a 17lb spring.

NOTE: The Glock 19/23 spring fits Glock 19 and 23 models and is a 18lb spring.

NP3 and NP3+ is protected by Trademark and registered as such to Coating Technologies LLC.