SUAREZ STANDARD HEIGHT TRITIUM REAR SIGHTS - FOR ALL GLOCKS
REAR SIGHT ONLY
These sights are standard height for use with non-red-dot pistols. .215" In height. They are the correct height for use with ALL Glock pistols, including the 42, 43, 43X and 48 models. They are made from US Bar Stock steel, precision machined and then finished in black melonite.
The rear sight features the Suarez designed “speed notch” (.150 wide, .120 deep) gives you faster acquisition of the front sight, and thereby the red dot, by allowing more visible light on each side. The rear sight installs with little to no fitting. After alignment, the rear sight locks into place with two machine screws. Add a little Loctite and your sights are easily aligned, usually without the need to use cumbersome sight tools. (Some slides may require a sight tool regardless). The rear sight contains one green vial of tritium, no white outline to distract the eye. The rear and front sight used together create a dot-on-top-of-dot image that is easily seen and is far less confusing than the typical three dots. Tritium installed by Trijicon.
The front face of the rear sight, serrated to 40 LPI in the same fashion as the rear face, allows you to clear your weapons with one hand in case of malfunction.
- Precision machined and then finished in black melonite
- Rear sight features the Suarez designed “speed notch”
- Rear sight installs with little to no fitting
- Rear Sight feature green tritium dots - no white outlines
- Tritium installed by Trijicon
- Rear sight will protrude past back edge of all MOS Glock model slides
- Made in the USA, Patent Pending design
SUGGESTED USE WITH TRITIUM FRONT SIGHT
GLOCK STANDARD HEIGHT
REAR: .215" NOTCH WIDTH: .150"
IDEAL USE: NO OPTIC, SHIELD RMS/RMS-C/RMS/RMS-W/SMS, JP ENTERPRISES J-POINT